How To Configure Access Lists & Route Between VLAN’s On HP v1910 24G

In the previous how to, we configured layer 3 static routes and VLAN’s on the HP v1910 24G you will have noticed that all traffic can pass between VLAN’s without any restrictions.  So why is this happening? Well the answer is because we have turned on routing by giving an IP Address to each VLAN.  This means the … Continue reading How To Configure Access Lists & Route Between VLAN’s On HP v1910 24G

How To Configure Layer 3 Static Routes & VLAN’s On HP v1910 24G

In the last how to, we performed the firmware upgrade and initial configuration on the HP v1910 24G. It’s now time to start  placing some VLAN’s onto our switch.  A good starting point is why do we use VLAN’s? Well a VLAN enables us to: Logically segment a switch into smaller switches, much same way that ESXi … Continue reading How To Configure Layer 3 Static Routes & VLAN’s On HP v1910 24G

How To Firmware Upgrade HP v1910 24G Switch & Initial Configuration

So, I finally have my lab all cabled and I have a few spare minutes to start the initial configuration of the vmFocus lab. What do we do first? Well I always start with networking and making sure that my switch is running the latest firmware.  OK, I do have one exception to this, when … Continue reading How To Firmware Upgrade HP v1910 24G Switch & Initial Configuration